Leupold Saw MT-100 Uživatelský manuál stáhnout pdf

MT-100 Wet/Dry Band Saw

User Guide

Thank you for buying this MTI product. Please take time to read all the instructions to understand

the correct components, set up, and use of the model you purchased.

Safety

• It is extremely important to wear proper eye protection when using any saw. We highly

recommend that you wear safety goggles rather than safety glasses.

• DO NOT wear loose clothing or any accessories (long necklaces, bracelets, shirts with

long fringes, and similar) that might get caught by the saw during operation.

• Use only in a properly grounded and tested outlet. Under NO circumstances should you

override the grounding system or modify the plug.

•

Set up your machine on a sturdy, level work surface that is water tolerant and a

comfortable height to work on.

Assembly Instructions

Exploded View

Assembly will take about 5 minutes and only requires a Phillips screwdriver. If a part is already

installed on your machine, skip to the next section. Use the exploded drawing on the following

page to reference parts during the assembly process.

1 2 3 4 5 6 7 8 9

1MT-100 Wet/Dry Band Saw User Guide Thank you for buying this MTI product. Please take time to read all the instructions to understand the correct c

2 Installing the Blade 1. Open the front cover of the saw. If you have a toothed blade, make sure to mount it with the teeth pointing downward, in

33. Use one hand to grasp the bottom of the upper wheel between two spokes and pull the bottom of the wheel towards you (approximately 3/8", bu

4left side of the saw’s frame and loosening the set screw on the brass arbor. Move the wheel to the correct position, check with the ruler or scale,

5a new BladeSert™ whenever you install a new blade.See the BladeSert™ User Guide for more information. Installing the Coolant Hose Holder and Coolan

6Optional Leather Wiper The leather wiper functions to help reduce the amount of over spray that might be carried from the blade to the upper wheel c

74. Make sure you have proper eye protection on before operating the saw. 5. Turn on the saw. The black control knob is located on the left side o

87) Pushing too hard will not increase cutting speed. It will actually slow it down. Use the speed control to adjust sawing speed to the material bei

9slot has worn out beyond the reach of the legs of the "X" (enhanced detail image) it is time to replace the BladeSert. It is no longer pro

Žádné komentáře

Leupold Saw MT-100 Uživatelský manuál